Quidway WB2011 Guía de usuario descargar pdf (Pagina 117)

Bridge Commands

6-37

bridge stp-port path-cost

Use this command to configure the spanning tree path cost for the specified port.

Use the no form to restore the default for the specified port.

Syntax

bridge stp-port path-cost <port> cost

no bridge stp-port path-cost <port>

• port - Specifies the port number on the wireless bridge. (Range: 0, Ethernet

interface; 1-16 wireless interface)

• cost - The path cost for the port. (Range: 1-65535)

Default Setting

• Ethernet interface – 19

• Wireless interface – 40

Command Mode

Global Configuration

Command Usage

• This command is used by the Spanning Tree Protocol to determine the best

path between devices. Therefore, lower values should be assigned to ports

attached to faster media, and higher values assigned to ports with slower

media.

• Path cost takes precedence over port priority.

Example

bridge stp-port priority

Use this command to configure the priority for the specified port. Use the no form to

restore the default for the specified port.

Syntax

bridge stp-port priority <port> priority

no bridge stp-port priority <port>

• port - Specifies the port number on the wireless bridge. (Range: 0, Ethernet

interface; 1-16 wireless interface)

• priority - The priority for a port. (Range: 1-255)

Default Setting

128

Command Mode

Global Configuration

Outdoor Bridge(config)#bridge stp-port path-cost 1 50

Outdoor Bridge(config)#

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 156 157

Sin comentarios

Quidway WB2011 Guía de usuario Pagina 117